WiFi Kit 32 is rebooting (solved)

[BEYOND]

I already had an ARDUINO IDE running and loaded the environment for the Heltec board as in the instructions.

Unfortunately, I can not load a sketch, nor any of the examples, without my board constantly restarting.

See the Serial output

ets Jun 8 2016 00:22:57

rst:0x1 (POWERON_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff0018,len:4
load:0x3fff001c,len:1100
load:0x40078000,len:10312
load:0x40080400,len:6460
entry 0x400806a4
ets Jun 8 2016 00:22:57

[joshua]

I had that problem last week and it turned out I had the wrong board chosen.

[Supporter]

@BEYOND

@Joshua had given the right answer. Correctly install our development framework and choose the right board. You can refer to this page:

Byteduino hardware cosigner wallet crashing

Hi there According to the situation we have collected so far, the most likely to cause a constant reset problem may have two reasons: Power supply problem: please make sure the voltage of USB ≥ 4.7V, 300mA; You chose an error board: because each type of board may have a different FLASH size, and they have a different partition map, it will cause the internal logic error.

[BEYOND]

Hello and many thanks,
Indeed i mixed up the Boards “Wirless Stick” and “Wifi Kit 32”.
Problem solved.