CubeCell and the Helium Network

#1

I am trying to get my CubeCell’s to talk to the Helium network. I am currently utilizing the Configurator. It some times takes a few trys and some resets, but it will usually Join and I get Activation on my console with Helium and the CubeCell will go into sending data at whatever specified interval is there but I never receive the uplink on the console.

I am fairly new and was able to get my HelTec Wifi Lora’s connected, but these seem to be a whole different animal.
Any help would be greatly appreciated.

#2

I am trying the same thing. I have been able to get a sporadic uplink and downlink using the Wireless Stick Lite. With the CubeCell, I haven’t been able to get anything but an Activation on the Helium console.

I thought it had something to do with sub-band 7 Helium is using, but I wasn’t able to figure out how to mask the channels for only 7.

#3

Well I am glad to see that it is not just me. There is some discussion on the Helium’s slack channel, I have talked some of the engineers at Helium to purchase the CubeCell to try and help me figure it out. Hopefully we will get it figured out.

#4

Well it now works sporadically on Helium. So there is progress.

#5

Have had some success with getting the Cubecell to join and send uplinks to the Helium network. I am now trying to adapt the MPU9250 to show roll, pitch, and yaw. Everytime I add the library for the MPU with the conversion I get board not supported.

#6

I’m trying the same thing with LoRa 32 V2 but no luck so far :frowning: If anyone has a success please share